CALL US

+86 17838360708

Evaluation of performance graded asphalt binder equipment

Evaluation of performance graded asphalt binder equipment

Evaluation of performance graded asphalt binder equipment ...

Evaluation of Performance Graded Asphalt Binder Equipment and Testing Protocol . By . Michael E. Pumphrey . Thesis submitted to the College of Engineering and Mineral

get price

Evaluation of Performance Graded Asphalt Binder Equipment ...

Evaluation of Performance Graded Asphalt Binder Equipment and Testing Protocol 5. Report Date April, 2004 6. Performing Organization Code 7. Author(s) John P.

get price

"Evaluation of performance graded asphalt binder equipment ...

Pumphrey, Michael E., "Evaluation of performance graded asphalt binder equipment and testing protocol" (2003). Graduate Theses, Dissertations, and Problem Reports.

get price

Evaluation of Performance Graded Asphalt Binder Equipment ...

Download Citation On Jan 1, 2004, John P. Zaniewski and others published Evaluation of Performance Graded Asphalt Binder Equipment and Testing Protocol Find, read

get price

Selection and evaluation of performance-graded asphalt ...

Ten conventional viscosity-graded asphalt cements, representing the asphalt typically available in Virginia, were graded under the PG system to develop a

get price

Pavement Manual: Performance Graded Binders (PG Binders)

Anchor: #i1013823 Section 5: Performance Graded Binders (PG Binders) Anchor: #i1013829 5.1 General. The Strategic Highway Research Program (SHRP) produced a

get price

Performance Graded Asphalt Binder

The Performance Graded Asphalt Binder (PGAB) Quality Control (QC)/Quality Assurance (QA) Program is designed to give Producers/Suppliers [henceforth Producer

get price

Performance Grade System for Asphalt Binder - Graniterock

The most advanced asphalt binder grading system is Performance Graded (PG) System, which is resulted from the $50 million Strategic Highway Research Program

get price

Performance Evaluation of a 100% Recycled Asphalt Pavement ...

The results for a typical dense-graded hot mix as-phalt (DG-HMA) were used in this study for refer-ence purposes to demonstrate the behavior of the evaluated G5

get price

Binder Characterization and Evaluation Volume 4: Test Methods

Pouring the Asphalt Binder Specimen ..... 20 Figure 2.4. An Asphalt Cement Binder Specimen Placed on the Supports ... Table 1.1 Performance-Graded Asphalt

get price

Selection and evaluation of performance-graded asphalt ...

Ten conventional viscosity-graded asphalt cements, representing the asphalt typically available in Virginia, were graded under the PG system to develop a cross-reference with the new system. Based on the past performance of the viscosity-graded asphalt and the PG binder testing, PG 64-22 was selected as the base grade of asphalt for Virginia.

get price

Performance Graded Asphalt Binder Quality Control/Quality ...

Asphalt Inspector to schedule an evaluation of any new employee hired.” 9/6/06, Page 22, Appendix I: Example Model Performance Graded Binder Quality Control Plan: Remove the existing scan ned images and reference the Department’s website for this section:

get price

Evaluation of Asphalt Binder Suppliers

• M 332, Performance-Graded Asphalt Binder Using Multiple Stress Creep Recovery (MSCR) Test • R 15, Asphalt Additives and Modifiers • R 26, Certifying Suppliers of Performance-Graded Asphalt Binders • R 28, Accelerated Aging of Asphalt Binder Using a Pressurized Aging Vessel (PAV) • R 29, Grading or Verifying the Performance Grade (PG ...

get price

A Performance-Graded Binder Specification for Surface ...

the U.S. One of the results of this endeavor was the development of a performance-based asphalt binder specification that relates laboratory analysis to field performance (6). SHRP researchers called this new classification method the Superior Performing Asphalt Pavements (Superpave) or performance-graded (PG) binder specification.

get price

PERFDRMANCE GRADED ASPHALT

design, it is anticipated that the use of a PG 52-40 binder on the Waterford CM-RS0225(3) project will result in very good performance. This project has provided good experience with a new product and performance should be monitored closely. 3. One post-construction performance evaluation has

get price

Performance Evaluation of a 100% Recycled Asphalt

The results for a typical dense-graded hot mix as-phalt (DG-HMA) were used in this study for refer-ence purposes to demonstrate the behavior of the evaluated G5 -stabilized RAP mixture in compari-Performance Evaluation of a 100% Recycled Asphalt Pavement Mixture using a Polymer Binder: A Pilot Study E. Y. Hajj

get price

Evaluation on Performance Characteristics of Superpave ...

a new grading system for asphalt binder (performance graded (PG) grading system), consensus properties of the aggregate, a new mix design procedure, and a mixture analysis procedure [5]. In recent years, studies have been conducted outside the USA to evaluate the feasibility and performance of Superpave-designed mixtures. For

get price

(PDF) Performance Evaluation of Hot Mix Asphalt with ...

In the hot mix recycling process, RAP material is combined with new aggregate and asphalt binder or recycling agent in a hot mix plant. With proper materials evaluation and mix design, similar or better performance can be achieved for hot mix asphalt combined with

get price

Forms and Manuals - New York State Department of ...

(Procedure for Performance-Graded (PG) Asphalt Binder Primary Sources) 06/2016: Materials Method 702-2 (Asphalt Emulsion - Quality Assurance) 03/2013: Materials Method NY8.4 M (Calibrating Micro-Surfacing Mix Units) 08/2001: Materials Method NY9.0 (Proportioning of Portland Cement Concrete) 10/1976: Materials Method MM9.1

get price

Evaluation of Overlay Tester Test Procedure to Identify ...

to help better understand the asphalt binder performance of the recycled asphalt and warm mix asphalt (WMA) modified materials. Conventional asphalt binder performance grading (PG), fracture testing, and rheologically-based test methods were utilized to evaluate the recovered asphalt binder. 7

get price

Binder performance and testing abstracts 20200221

extracted and recovered asphalt binders Sarah Bird, Marissa Matthews, Simon Hesp Queen's University, Kingston, Ontario, Canada Abstract: Acceptance grading of asphalt binder is crucial for the control of pavement performance. Hot mix asphalt (HMA) taken directly from the paving equipment represents the actual material placed,

get price

CHIP SEALS FOR ASPHALT CONCRETE PAVEMENTS: A

to characterize asphalt binder properties related to the performance of hot mix asphalt concrete in pavements, cannot be directly applied to asphalt binders or emulsion residues for use in chip seals. Therefore, the surface performance graded (SPG) specification was developed using the same equipment as the PG system but with some procedural

get price

Evaluation of Warm Mix Asphalt Technologies and Anti

Evaluation of Warm Mix Asphalt Technologies and Anti-Strip Additives NTPEP Designation: WMA-01-19 ... and equipment. It does not purport to address all safety problems associated with its use. It is the responsibility of the user of this ... Standard Specification for Performance-Graded Asphalt Binder AASHTO M 332, Standard Specification for ...

get price

Performance Evaluation of Bone Glue-Modified Asphalt

2.3. Preparation of Asphalt Mixture Samples. For preparation of asphalt mixture samples, NHA class B gradation was used. To find optimum binder content, Marshall mix design (ASTM D1559) was used for BG-modified asphalt samples for three percentages (3%, 6%, and 9% by weight of bitumen). 75 blows of standard hammer having weight 4.5 lbs and height of fall 18 inch were applied on both sides of ...

get price

Performance Graded Asphalt Binder Quality Control/Quality ...

Asphalt Inspector to schedule an evaluation of any new employee hired.” 9/6/06, Page 22, Appendix I: Example Model Performance Graded Binder Quality Control Plan: Remove the existing scan ned images and reference the Department’s website for this section:

get price

ASPHALT BINDER

Asphalt Performance Grading (PG) The required PG grading for a specific location can be determined based on high and low pavement temperature High pavement temperature is calculated at a .8” (20 mm) depth based on seven-day average high air temperature and the geographic latitude of the project Low pavement surface temperature is

get price

SUPERPAVE PERFORMANCE GRADED BINDER TESTS

Superpave Performance Graded Binder Tests 8 Pavement Behavior (Low Temperatures) • Thermal cracks – Stress generated by contraction due to drop in temperature – Crack forms when thermal stresses exceed ability of material to relieve stress through deformation • Material is brittle • Depends on source of asphalt and aggregate properties

get price

Asphalt Binder - 17

2.1 Binder - An asphalt based cement that is produced from petroleum residue either with or without the addition of non-particulate organic modifiers. 2.2 PG - Performance Graded, as in Superpave Performance Graded Binders. 2.3 Refinery Facility - A facility that is a producer of petroleum asphalts by refining the residuum from crude petroleum ...

get price

Performance Evaluation of Reclaimed Asphalt Pavement in ...

Performance Evaluation of Reclaimed Asphalt Pavement in Hot Mix Asphalt Modified with Organosilane by ... aggregate and asphalt binder. The use of OS also reduces the mixing and compaction ... The OS reduced the sticking nature of the binder to the molds and equipment, which reduced the efforts in cleaning them.

get price

ALDOT-341 Independent Assurance Program

Performance Graded Asphalt Binder Technician Level I . Performance Graded Asphalt Binder Technician Level II . Category “B” Technician . ... The first unsatisfactory evaluation due to deficient equipment will result in a strike against the equipment. 1.3.5 Evaluating Personnel .

get price

Binder performance and testing abstracts 20200221

extracted and recovered asphalt binders Sarah Bird, Marissa Matthews, Simon Hesp Queen's University, Kingston, Ontario, Canada Abstract: Acceptance grading of asphalt binder is crucial for the control of pavement performance. Hot mix asphalt (HMA) taken directly from the paving equipment represents the actual material placed,

get price

Performance Evaluation of Bone Glue-Modified Asphalt

2.3. Preparation of Asphalt Mixture Samples. For preparation of asphalt mixture samples, NHA class B gradation was used. To find optimum binder content, Marshall mix design (ASTM D1559) was used for BG-modified asphalt samples for three percentages (3%, 6%, and 9% by weight of bitumen). 75 blows of standard hammer having weight 4.5 lbs and height of fall 18 inch were applied on both sides of ...

get price

for Lower Volume Local Roads

Standard Specifications for Performance-Graded Asphalt Binder, AASHTO M 320, except as revised in Bulletin 25. Obtain material from a source listed in Bulletin 15 for the specified grade. Provide QC testing and certification as specified in Pub. 408 Sections 106.03(b) and 702.1(b)1. Provide the Representative

get price

AASHTO - M 320 - Standard Specification for Performance ...

Jan 01, 2021  Note 1-For asphalt cements graded by viscosity at 60°C, see M 226. Note 2-R 29 provides information for determining the performance grade of an asphalt binder. Note 3-For specifying performance-graded asphalt binder using Multiple Stress Creep Recovery (MSCR), see M 332.

get price

Binder Characterization and Evaluation Volume 4: Test

Pouring the Asphalt Binder Specimen ..... 20 Figure 2.4. An Asphalt Cement Binder Specimen Placed on the Supports ... Table 1.1 Performance-Graded Asphalt Binder Specification ..... 13 Table 1.2. Reproducibility of Dynamic Shear Measurements ... Binder Characterization and Evaluation Volume 4: Test Methods describes the development

get price

Evaluation of Open-Graded Friction Course (OGFC) Mix ...

specifications of binder and the 1/2 in. OGFC gradation and aggregate quality were used in this study. The NCAT approach includes selection of optimum gradation, selection of optimum asphalt binder content, and evaluation of moisture susceptibility using a modified Lottman method in accordance with AASHTO T 283 with one freeze-thaw cycle.

get price

Evaluation of Fiber-Reinforced Asphalt Pavements ...

The constructed project is a 3.22-mile road stretch where 0.4 ft of the existing asphalt surface was milled and replaced by a new HMA overlay. The project length was divided into four sections that are approximately equal in length. Three sections were built with fiber-modified dense graded asphalt mixes.

get price

AASHTO MP 1 - Standard Specification for Performance ...

Jan 01, 1998  Note 1 - For asphalt cements graded by penetration at 25°C, see M20. For asphalt cements graded by viscosity at 60°C, see M226. Note 2 - Guide PP5 provides information on the evaluation of modified asphalt binders. Note 3 - Guide PP6 provides information for determining the performance grade of an asphalt binder.

get price